MasaApps360
English
Don't TouchDon't Touch

Can an iPhone work as an anti-theft alarm for a bike or motorbike?

For short stops, in part. Arm Don't Touch, leave the phone on the bike and any push, tilt or tug sets off a loud siren until someone types the PIN. It is an alarm on the phone, not a tracker, and it only works while the app stays open with the screen on.

3 min read · Updated

What to expect

Don't Touch reads the iPhone's accelerometer while it is armed. If the bike is shoved, rocked or lifted, the phone moves with it and the siren starts. The sound is meant to make a thief hesitate and to make you turn around. It does not lock the wheel, it does not know where the bike is, and it cannot call anyone.

Because the screen has to stay on and the app has to stay in front, this suits a few minutes at a time: a quick stop at a shop, a break on a trip, or a bike parked in a garage or at a campsite where you can hear it. It is not a way to guard a bike left overnight on the street, and a phone left in plain sight can itself be taken.

Set it up for a vehicle

  1. Open Don't Touch and set your 4-digit PIN the first time. Allow motion access when iOS asks.
  2. Go to Settings. Under Motion Sensitivity, start near the bottom (the label reads Low — needs a firm bump). A bike or motorbike shakes in the wind and when traffic passes, so a hair-trigger setting will go off on its own.
  3. If the phone is on a charger or battery pack, leave Charger Alarm on. Pulling the cable out then sets off the siren too. It only works if the cable was plugged in when you armed.
  4. Check Arm delay (0 to 15 seconds, 5 by default). Raise it to 10 or 15 so you have time to get off and step away.
  5. Mount the phone firmly on the handlebars or tank bag, or lay it on a stable seat, then tap ARM. The screen says Arming — put your phone down now and counts down.
  6. Wait for Armed. Don't touch it. and walk away. When you come back, tap DISARM and enter the PIN.

Since 1.3.0 there is also a Bike / Motorbike mode in Settings with its own vibration sensitivity, a live meter under Calibrate Vibration and a short debounce that ignores single wind ticks.

Wind, engine and passing trucks

The app compares each reading with a slow-moving average of how the phone is resting, so a steady tilt is ignored. Short, sharp ticks are another matter: a gust, a passing lorry or a loose mount can look like a bump to the sensor. If the alarm goes off by itself, lower the sensitivity slider and test again. Never arm the phone while the engine is running or while you are riding.

What it does not do

  • It is not a tracker. It cannot show where the bike went and it cannot lock or erase a phone that has been taken. For that, turn on Find My separately.
  • It stops watching if you leave the app, lock the screen or the battery dies. Keep the app open and the phone charged.
  • It does not replace a lock. Use a good lock and treat the siren as an extra warning.
  • It will not say that a bike is safe, only that it made noise when the phone moved.

Questions and answers

Can I use my iPhone as a motorbike alarm?
As a deterrent for short stops, yes: arm Don't Touch with the phone on the bike and it sounds a siren if the phone is moved. It is not a tracker and it does not stop a determined thief.
Will the alarm go off from wind or engine vibration?
It can if sensitivity is too high. Set Motion Sensitivity low, test with a gentle push and raise it only if the siren stays silent.
Does it keep working with the screen locked?
No. The app keeps the screen awake while armed and has to stay open. If you leave the app or lock the screen, it stops watching.
Can it tell me where my bike is?
No. It only makes noise on the phone. It has no location tracking.

More Don't Touch guides