MasaApps360
English
PoolDosePoolDose

Calcium hardness pool calculator

Calcium chloride raises calcium hardness by about 1.5 g per cubic metre for every ppm, which is 1.25 lb per 10,000 gallons for 10 ppm. A 20 m³ pool going from 150 to 250 ppm takes 3.00 kg. The Calcium hardness product in Dosing does the sum.

2 min read · Updated

How is the calcium chloride dose calculated?

Hardness is reported in ppm as calcium carbonate. Calcium chloride dihydrate weighs 147 g per mole against 100 g for calcium carbonate, which gives 1.47 g per m³ per ppm. The app uses 1.5 g, the same figure as the common trade table of 1.25 lb per 10,000 gallons for 10 ppm.

Check the label: other grades of calcium chloride are stronger or weaker than the dihydrate the rate assumes, and a stronger grade needs proportionally less.

Pool calcium hardness calculator

Units
Calcium chloride to add
3.00 kg
Reference rate for 10 ppm
1.25 lb / 10,000 gal · 150 g / 10 m³

Showing the worked example. Turn on JavaScript to calculate your own numbers.

Calcium chloride (dihydrate) raises calcium hardness by about 1.5 g per m³ for every ppm (1.25 lb per 10,000 gal for 10 ppm). Dissolve it in a bucket of water first, as the label says. Follow the product label, add chemicals one at a time and never mix them.

How do I get the hardness dose in PoolDose?

  1. Open Dosing and set Product to Calcium hardness.
  2. Type Pool volume (m³), or leave the volume from the Volume calculator.
  3. Enter Measured (ppm) from your test kit and Target (ppm).
  4. Read the weight under Dose, with the reference rate for 10 ppm underneath.
Examples
PoolChangeDose
20 m³150 to 250 ppm3.00 kg
50 m³150 to 250 ppm7.50 kg
10 m³200 to 210 ppm150 g
10,000 gal (US units)200 to 210 ppm1.25 lb

How do I add it?

Calcium chloride gives off heat when it meets water, so labels usually tell you to dissolve it in a bucket of water first and pour that in, rather than dropping dry flakes into the pool.

  1. Follow the product label and add chemicals separately, one at a time, never mixed together.
  2. Dissolve the amount in a bucket of water, as the label says, and pour it around the pool with the pump running.
  3. Wait for the water to circulate, then test calcium hardness again and type the new value as Measured (ppm).

The target is the number you type. Your test kit, your pool surface and the product label are the references to follow, not the app.

Questions and answers

How much calcium chloride raises hardness by 10 ppm in 10,000 gallons?
About 1.25 lb (570 g). In a 10 m³ pool the same 10 ppm takes 150 g.
Can I add everything in one go?
A smaller first dose followed by a new test is easier to correct, and the label may set a limit for one addition.
Does it work without internet?
Yes, PoolDose does the dosing arithmetic on the phone, with no account and no connection.

More PoolDose guides