MasaApps360
English
Don't TouchDon't Touch

Motorbike alarm on iPhone: calibrate the vibration sensitivity

In Bike / Motorbike mode, Don't Touch shows a live vibration bar with an alarm line. Put the phone where it will stay, raise Vibration Sensitivity until the bar crosses the line only when you shove the bike, then arm it. It is a deterrent alarm on the phone, not a tracker.

2 min read · Updated

Switch to the vehicle mode

Open Settings and, under Alarm Mode, choose Bike / Motorbike instead of Standard. The mode has its own sensitivity, its own arm delay and a short filter that ignores brief ticks from wind or a cooling engine. Pocket Alarm is switched off in this mode.

Calibrate on the real mount

  1. Fix the phone where it will stay: the mount on the handlebar, a tank bag or a pannier. Calibrate there, not on the table.
  2. In Settings, tap Calibrate Vibration. A bar and a white line appear under Vibration level.
  3. Leave the bike alone for a few seconds. The status should read Quiet: below the alarm line.
  4. Push the bike the way a thief would. The bar should cross the line and the status change to Over the line: the alarm would sound.
  5. Move the Vibration Sensitivity slider until the bar crosses the line for a shove but not for a passing car or a gust.
  6. Press Test Alarm (3s) once to hear the siren at the volume you will use.

What the slider changes

Sensitivity sets the alarm line, measured in g, the unit of the phone's motion sensor. A lower line reacts to smaller movements.

Sensitivity and alarm line in Bike / Motorbike mode
SliderLabel under itAlarm line
0 (far left)Low — needs a firm bump0.35 g
0.3Medium begins0.26 g
0.5 (default)Medium0.20 g
0.7High — any small nudge begins0.14 g
1 (far right)High — any small nudge0.05 g

Standard mode uses a wider scale (0.50 g down to 0.08 g) and sounds on a single reading. The vehicle mode wants three readings in about 0.4 seconds, so one gust or one tick does not count, while a shove or a lift lasts long enough to.

Arm delay

The Arm delay stepper in this mode runs from 5 to 60 seconds in steps of 5, 20 by default. It is the time you have to move your hand away and step back before the phone starts to watch.

Questions and answers

How do I make a motorcycle alarm on my phone less sensitive?
Open Settings, choose Bike / Motorbike, tap Calibrate Vibration and move the Vibration Sensitivity slider toward Low until the bar stays under the line in wind and traffic.
What does the number in g mean?
It is the movement the phone's motion sensor feels, compared with how the phone was resting. About 0.2 g, the default line, is a clear push.
Why does the vehicle mode wait for three readings?
A single wind tick or engine tick lasts one reading. A shove lasts several, so asking for three in 0.4 seconds ignores the first and catches the second.
Can the alarm text me or show where the bike is?
No. It sounds the siren on the phone and nothing else.

You might also like

More Don't Touch guides