Fillet weld symbol: what the size and length numbers mean
On a fillet symbol the size goes to the left of the triangle and the length and pitch to the right. 1/4 on the left and 2–6 on the right is a 1/4" fillet, 2" long, every 6" centre to centre.
Where each number goes
- Left of the triangle: the fillet size. In AWS it is the leg length.
- Right of the triangle: the length of each weld, then the pitch (centre to centre) when the weld is intermittent.
- No number on the right: the fillet runs the full length of the joint.
- Triangle below the line: arrow side. Above the line: other side. Both: a weld on each side.
| On the drawing | What to weld |
|---|---|
| 1/4 on the left, nothing on the right, below the line | 1/4" fillet along the whole joint, arrow side |
| 1/4 left, 2–6 right, below the line | 1/4" fillets, each 2" long, 6" centre to centre, arrow side |
| 3/8 left, triangles above and below | 3/8" fillet on both sides of the joint |
| ISO: a5 left, 3×50 (100) right | Throat 5 mm, 3 welds of 50 mm, with a 100 mm gap |
Chain or staggered intermittent welds
When a joint is welded on both sides with short welds, the two rows can line up or alternate. In a chain intermittent weld the welds on the two sides sit opposite each other. In a staggered one they are offset by half a pitch, so a weld on one side faces a gap on the other. The drawing shows which one by how the two triangles are placed along the line.
AWS leg size vs ISO throat
AWS gives the leg of the fillet. ISO gives either the throat thickness, written a5, or the leg length, written z7. For an equal-leg flat fillet the throat is about 0.707 times the leg, so a 1/4" leg has a throat near 0.177" and an ISO a5 weld has a leg near 7 mm.
| Leg (z) | Throat (a) |
|---|---|
| 6 mm | 4.2 mm |
| 8 mm | 5.7 mm |
| 1/4" | 0.177" |
| 3/8" | 0.265" |
Read it in WeldMaster
- Open Weld Symbols from Reference on the main screen.
- Tap Read a weld symbol and pick Fillet under Symbol.
- Switch between Arrow side, Other side and Both sides to see the triangle move.
- Check Where the numbers go for the size and length-pitch layout, and AWS and ISO differ for the a and z notation.
Questions and answers
What does the number on the left of a fillet weld symbol mean?
What does 2–6 mean on a weld symbol?
What is the difference between chain and staggered intermittent welds?
How do I convert fillet leg to throat?
You might also like
- Welding symbols chart explained: arrow side, other side and the numbers · WeldMaster
- How to calculate heat input in welding, in kJ/in and kJ/mm · WeldMaster
More WeldMaster guides
- MIG welding settings chart: voltage, wire speed and gas by metal thickness
- Flux core welding settings and polarity: gasless vs dual shield
- Stick welding amperage chart for 6010, 6011, 6013, 7014, 7018 and 7024 rods
- Carbon equivalent formula and preheat temperature for welding A36, 4140 and carbon steel
- MIG porosity, spatter and burn-through: causes and how to fix them
- All questions about WeldMaster
- Back to WeldMaster