Groove weld symbols: V, bevel, U and J
A groove symbol draws the shape of the edge preparation. A V means both edges are bevelled, a bevel means only one is, and a U or J means the edge is machined to a curve.
The groove symbols side by side
| Symbol | What it describes | What to look for |
|---|---|---|
| Square groove | Edges butted together with a root gap and no bevel | Two parallel vertical lines |
| V-groove | Both edges bevelled so the joint forms a V | The point of the V touches the reference line |
| Bevel groove | Only one piece is bevelled | Vertical leg on the left, arrow bends toward the bevelled piece |
| U-groove | Both edges machined to a rounded U, common on thick plate and pipe | The curve touches the reference line |
| J-groove | One piece machined to a J with a curved root, the other stays square | Vertical leg on the left, arrow bends toward the prepared piece |
| Flare-V groove | Joint between two rounded surfaces, such as two bars or pipes side by side | Two curved sides forming a V |
| Flare-bevel groove | Joint between one rounded and one flat surface | Vertical leg on the left, arrow bends toward the rounded piece |
Why the arrow bends
With a bevel, J or flare-bevel groove only one piece is prepared. The arrow is drawn with a bend toward that piece, so the welder knows which edge to bevel. A V or U is symmetrical, so its arrow is straight.
Where the numbers go
- The groove angle and the root opening are written with the groove symbol.
- The tail holds notes such as the welding procedure or the process.
- Below the line is the arrow side. If the groove is on the other side, the symbol goes above the line.
- A groove drawn on both sides of the line is prepared and welded from both faces.
Look them up in WeldMaster
- Open Weld Symbols from Reference and scroll to Basic symbols.
- Tap V-groove, Bevel groove, U-groove or J-groove for the description and the drawing.
- In Read a weld symbol, pick one under Symbol and flip Arrow side, Other side and Both sides to see where it sits.
Questions and answers
What is the difference between a V-groove and a bevel groove symbol?
A V-groove bevels both edges and has a straight arrow. A bevel groove bevels one piece only, so the arrow bends toward it.
Why does the arrow on a bevel symbol have a bend?
The bend points to the piece that gets the bevel. Without it the welder would not know which edge to prepare.
Where do groove angle and root opening go?
With the groove symbol itself. The tail is for notes such as the procedure.
What does a U-groove symbol mean?
Both edges are machined to a rounded U, typically on thick plate and pipe.
You might also like
- Welding symbols chart explained: arrow side, other side and the numbers · WeldMaster
- Fillet weld symbol: what the size and length numbers mean · WeldMaster
More WeldMaster guides
- MIG welding settings chart: voltage, wire speed and gas by metal thickness
- Flux core welding settings and polarity: gasless vs dual shield
- Stick welding amperage chart for 6010, 6011, 6013, 7014, 7018 and 7024 rods
- Carbon equivalent formula and preheat temperature for welding A36, 4140 and carbon steel
- MIG porosity, spatter and burn-through: causes and how to fix them
- All questions about WeldMaster
- Back to WeldMaster